NO-MAR PRESS BRAKE DIE FILM

Bending metal can sometimes result in a less-than-perfect finish. Especially when working with stainless steel or aluminum. Simply by using No-Mar, you can greatly reduce or even eliminate marks or defects caused by your press brake die. Made of ultra-strong polyurethane, No-Mar provides high friction resistance during correct bending application and one piece of film can be used over and over again.

• NO-MAR PRESS BRAKE DIE FILM is available in three different widths: 50mm, 102mm, and 152mm. Simply cut it to the length required and place it over your press brake die.
• NO-MAR PRESS BRAKE DIE FILM can be used with any press die or material. Once positioned, either tape or clamp it in place.
• BEND YOUR MATERIAL as you would normally. Depending on the material, its thickness, and the force applied – No-Mar Press Brake Die Film can be used many times over.  

Dimensions:

• 50mm, 102 mm or 152 mm wide

Length of roll:

• 30 m

Thickness:

• 0.4 mm

Material:

• Polyurethan

5% OFF IF YOU BUY A BOX

•   50 mm Box: 24 rolls
• 102 mm Box: 12 rolls
• 152 mm Box:  8 rolls