BEND METAL WITHOUT MARKING IT!

11 May 2020Stef H

Put an end to marks with "No-Mar"

Save materials, money and time, all at once, simply by using No-Mar Press Brake Die Film in your bending process.

Bending metal can sometimes result in a less than perfect finish. Especially when working with stainless steel or aluminium.

Simply by using No-Mar from Aotea, you can greatly reduce or even eliminate marks or defects caused by your press brake die.

Made of ultra strong polyurethane, No-Mar provides high friction resistance during correct bending application and one piece of film can be used over and over again.

BUY A BOX AND GET 5% DISCOUNT

 

How to use No-Mar in the bending process to reduce or eliminate marks

  • NO-MAR PRESS BRAKE DIE FILM is available in both 100mm and 150mm widths. Simply cut it to the length required and place it over your press brake die.
  • NO-MAR PRESS BRAKE DIE FILM can be used with any press die or material. Once positioned, either tape or clamp it in place.
  • BEND YOUR MATERIAL as you would normally. Depending on the material, its thickness and the force applied – No-Mar Press Brake Die Film can be used many times over.

 

Dimensions:          100mm and 150mm wide

Length of roll:       30m

Thickness:             0.015mm

Material:                Polyurethane

Cookie consent